Filter
Top Products
STEP
2
A. See Note 1. Install 210mm (8 1/4”) long bolt (21) thru left side of seat brace (H), and then seat pivot (G), and
then thru right side seat brace (H), using the center hole on each seat brace as shown. Use the following:
one 21 (hex bolt 10mm x 210mm partial thread)
two 36 (flat washer 10mm)
one 32 (nylon lock nut 10mm)
B. See Note 2. Install 165mm (6 1/2”) bolt (22) thru the lower hole on the left side of back brace (J),
and then thru the adjustment carriage (E), and then thru the right side of back brace (J) as shown using:
one 22 (hex bolt 10mm x 165mm partial thread)
two 36 (flat washer 10mm)
one 32 (nylon lock nut 10mm)
C. See Note 3. Install 165mm (6 1/2") bolt (22) thru left side of back brace (J), and thru back pivot on
mainframe (B), and then thru right side of back brace (J) as shown using:
one 22 (hex bolt 10mm x 165mm partial thread)
two 36 (flat washer 10mm)
one 32 (nylon lock nut 10mm)
D. See Note 4. Connect seat braces (H) and back braces (J). Install as shown and described using:
two 25 (hex bolt 10mm x 60mm partial thread)
four 36 (flat washer 10mm)
two 32 (nylon lock nut 10mm)
5
mm
Inch
Be careful to assemble all components
in the sequence they are presented.