A SERVICE OF

logo

Open as PDF
next previous
4 Replacement Procedures 4.23 LCD unit
4-98 CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
Installing the LCD unit
To install the LCD unit, follow the steps below and refer to Figure 4-51 to 4-57.
1. Set the brake hinges to the LCD unit and secure them with the following screws.
• M2.0×3C BIND screw ×4
NOTE: When replacing the brake hinge R with a new one, stick the hinge cover to the
brake hinge R in place.
2. Connect the LCD harness to the connector on the LCD unit and secure it with the
pull tape.
3. Turn the brake hinge R 90 degrees.
4. Set the LCD unit on the LCD cover and secure them with the following screws.
• M2.5×5B FLAT HEAD screw ×4
NOTE: When securing the LCD unit and LCD cover, be sure to secure the screws in the
order of the number on the Figure 4-55.