A SERVICE OF

logo

4 Replacement Procedures 4.19 System board
4-68 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
Removing the System board
To remove the system board, follow the steps below and refer to Figure 4-38 and 4-39.
1. Take out the RJ45 harness from the slot of the base assembly.
2. Peel off the insulator (SQUARE INSULATOR).
3. Remove the following screws securing the system board.
M2.5×6C Tapping screw ×2
4. Remove the system board from the base assembly.
CAUTION: When removing the system board, lift up the right side of the system board
first.
Figure 4-38 Removing the system board (1)
System board
M2.5x6C Tapping
RJ45 harness
M2.5x6C Tapping
Insulator
(SQUARE INSULATOR)