A SERVICE OF

logo

4.20 CPU/Fin/DC fan 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-73
4.20 CPU/Fin/DC fan
Removing the CPU/Fin/DC fan
To remove the CPU/fin/DC fan, follow the steps below and refer to Figure 4-40 to 4-42.
1. Disconnect the fan harness from the connector CN3380 on the system board.
2. Remove the following screws and fin (with the DC fan).
M2.0×4B BIND screw ×8
NOTE: When removing the fin, be sure to remove the screws in the reverse order of the
number marked on the fin.
3. Disconnect the DC-IN harness from the connector CN8800 on the system board.