A SERVICE OF

logo

4 Replacement Procedures 4.18 RGB/USB board
4-64 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
4.18 RGB/USB board
Removing the RGB/USB board
To remove the RGB/USB board, follow the steps below and refer to Figure 4-36 and 4-37.
1. Disconnect the RGB harness from the connector CN9611 on the RGB/USB board.
2. Remove the following screw securing the RGB/USB board.
M2.5×6C Tapping screw ×1
Figure 4-36 Removing the RGB/USB board (1)
RGB harness
M2.5x6C Tapping
CN9611