A SERVICE OF

logo

4 Replacement Procedures 4.18 RGB/USB board
4-66 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
Installing the RGB/USB board
To install the RGB/USB board, follow the steps below and refer to Figure 4-36 and 4-37.
1. Connect the USB harness to the connector CN9610 on the RGB/USB board and
arrange the harness in place.
2. Set the RGB/USB board to the slot of the base assembly.
3. Set the DC-IN harness to the slot of the base assembly.
4. Secure the RGB/USB board with the following screw.
M2.5×6C Tapping screw ×1
5. Connect the RGB harness to the connector CN9611 on the RGB/USB board.