Reelmaster 5010 Series Hydraulic System (Rev. C)Page 4 -- 81
Front Wheel Motor Service (Eaton)
1. Cap screw (7 used)
2. End cap
3. O--ring (3 used)
4. Geroler assembly
5. Valve plate
6. Thrust bearing
7. Bearing
8. Valve
9. Dowel pin (4 used)
10. Balancing ring
11. Valve spring
12. Back--up ring
13. O--ring
14. Drive
15. Output shaft
16. Bearing race (2 used)
17. Thrust bearing
18. Shaft seal
19. Housing
20. Bearing
21. Grease seal
Figure 69
(61to75N--m)
45 to 55 ft--lb
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
19
20
4
21
3
3
12
16
NOTE: Machineswithserial numberabove311000600
were produced with Eaton brand front wheel motors. If
front wheel motors were replaced for some reason on a
machine with serial number below 311000600, the re-
placement wheel motors may have been Eaton brand.
Wheel motors have an identification tag on them which
identifies the brand. Right and left motors are the same
basic design but the right side motors have a reverse
timed manifold to allow correc t rotation direction for for-
ward and reverse.The left side wheel motors areidenti-
fied with either a machined groove or a painted yellow
mark on the end of the output shaft.
NOTE: On machines equipped with optional Cross-
Trax
TM
AWD kit, the rear wheel motors are Parker Torq-
motor
TM
TL Series.
NOTE: For Eaton wheel motor repair procedures, see
the Eaton Delta Motors Parts and Repair Manual at the
end of this chapter.
IMPORTANT: Ifawheelmotorfailureoccurred,refer
to Traction Circuit Component Failure in the Gener-
al Information section for informationregarding the
importance of removing contamination from the
traction circuit.
Hydraulic
System
