Chapter 2 Managing RAS Features and System Firmware 45
2. Set the obdiag-trigger variable to any combination of power-on-reset,
error-reset, and user-reset. For example, type:
Note – For more information about OpenBoot configuration variables, refer to the
Netra 440 Server Diagnostics and Troubleshooting Guide (817-3886-xx).
3. To cause the parameter changes to take effect, type:
The system permanently stores the parameter changes and boots automatically
when the OpenBoot configuration variable auto-boot? is set to true (its default
value).
Note – To store parameter changes, you can also power cycle the system using the
front panel Power button.
▼ To Disable Automatic System Recovery
1. At the ok prompt, type:
2. To cause the parameter change to take effect, type:
The system permanently stores the parameter change.
Note – To store parameter changes, you can also power cycle the system using the
front panel Power button.
After you disable the automatic system recovery (ASR) feature, it is not activated
again until you enable it at the system ok prompt.
ok setenv obdiag-trigger power-on-reset error-reset
ok reset-all
ok setenv auto-boot-on-error? false
ok reset-all
