30 Netra 440 Server System Administration Guide • August 2004
Note – There are many other OpenBoot configuration variables. Although these
variables do not affect which hardware device is used to access the system console,
some of them affect which diagnostic tests the system runs and which messages the
system displays at its console. For details, refer to the Netra 440 Server Diagnostics
and Troubleshooting Guide (817-3886-xx).
7. To cause the changes to take effect, type:
The system stores the parameter changes, and boots automatically when the
OpenBoot configuration variable auto-boot? is set to true (its default value).
Note – To store parameter changes, you can also power cycle the system using the
front panel Power button.
You can issue system commands and view system messages using your local
graphics monitor. Continue with your installation or diagnostic procedure, as
needed.
If you want to redirect the system console back to the serial management and
network management ports, see
“System Console OpenBoot Configuration Variable
Settings” on page 31.
ok reset-all
