English
10
Contents (filling set 0722152):
❚ 1x Syringe
❚ 1x Hose for syringe
❚ 1x MAGURA-Blood, 75 ml Vitam LS
❚ 2x Sealing rings for pipe connector
Tools:
❚ SW 6 wrench
Filling and bleeding:
TIP: The HYMEC system should already be installed on
the motorcycle!
❚ Position the master cylinder horizontally on the handlebar and
remove cover with bellows.
❚ Place hose on syringe and fill it half full with MAGURA-Blood.
❚ Place on bleeder valve and open valve by about 3/4 of a turn
❚ Now fill system up to the top edge of the master reservoir.
❚ Now pull back the syringe piston until the oil level in the con-
tainer sinks almost to the bottom. While doing this hold the
syringe above if possible. IMPORTANT: The bottom of the
reservoir must still be covered with oil otherwise air will be
sucked in!
❚ Now pump oil into the system again. Repeat this procedure
3-4 times until no more bubbles rise up into the syringe.
❚ Fill system until the oil level in the reservoir is about 6 mm
from the top edge of the reservoir. Mount cover and bellows.
Tightening torque 1.6 Nm!
❚ Close valve. Tightening torque 1.6 Nm! Withdraw syringe and
replace cap.
HYMEC Filling instructions
Important information:
❚ In the case of doubt arrange to have the repair carried out by a specialist workshop!
❚ In the event of damage of the system due to improper installation, MAGURA will not be
responsible for replacement!
❚ Foreign bodies or contamination in the clutch system can lead to increased wear. Always
make sure that no foreign particles can penetrate the system (e.g. via an open master unit).
The necessary work should only be carried out with clean components and resources and in
a clean environment.
❚ Only MAGURA-Blood may be used for filling, never brake fluid!
❚ Used oil must be disposed of according to the current regulations and laws.
