7-44
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 7 SPVC and SVC Commands
dspcons
AXSM Syntax
dspcons
[-conn <conn id>]
[-filt <filter options>]
[-if <intf no>]
[-vpi <vpi filter>]
[-vci <vci filter>]
AXSM Syntax Description
Related Commands
dspcon, addcon, cnfcon, delcon, dncon, upcon
PXM45 Attributes
AXSM Attributes
-conn The connection ID (conn ID) of the connection to begin the display. The
format of conn ID is:
ifNum.vpi.vci
The logical port number. The range for AXSM is 1–60.
The VPI has the
range 0–4095. The VCI has the range 32–65535.
-filt Unlike on the PXM45, you do not use keywords for this parameter on the
AXSM. You enter only a number on the AXSM CLI to indicate the state. The
display criteria are:
1 ingr—for errors in the ingress direction
2 egr—for errors in the egress direction
3 condn—for connections where the switch has conditioned the connection
4 iffail—for connection on a failed logical interface
5 ccfail
6 mis
7 abit—for connections where an A-bit error has occurred
-if A particular logical interface for connection display.
-vpi
The VPI of all the connections that you would like to display.
-vci
The VCI of all the connections that you would like to display.
Log: no log State: active, standby Privilege: ANYUSER
Log: no log State: active, standby Privilege: GROUP1
