5-30
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 5 PNNI Commands
cnfpnni-node
Note In the current release, you must keep the default values for -lowest, -complexNode, and
-branchingRestricted.
Caution Cisco factory-set defaults for address prefixes and the peer group ID share field values with the ATM
address. If you change the peer group ID, you should change the corresponding fields in the ATM
address and node identifier. (See Figure 5-6 for the mapping between these addresses.)
-complexNode Specify whether this node is a complex node. The lowest-level node cannot
be a complex node.
on: This node is a complex node.
off: This node is not a complex node.
Default: off
Note This release does not support multiple peer groups, so this
parameter must remain off.
-branchingRestricted Specify whether the PNNI node allows point-to-multipoint branches.
on: This node does not allow point-to-multipoint branches.
off: This node allows point-to-multipoint branches.
Default: on
Note This release does not support branching, so this parameter must
remain on.
