3-17
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 3 Equipment and Resource Provisioning
addport
Related Commands
cnfport, delport, dspport, dspports, dspportsct
Attributes
Example
Create logical port 1 on line 1, bay 1. Currently, the minimum and maximum cells per second must be
the same and are 96000 cps in this example. The egress SCT file ID is 4. The interface type is NNI (2).
MGX8850.9.AXSM.a > addport 1 1.1 96000 96000 4 2
sctID The ID of a service class template (SCT) for the port. The range is 0–255. The
SCT file must exist on the PXM45 disk. See cnfcdsct.
Cisco Systems provides SCT numbers 2 and 3. You can create more SCTs by
modifying an existing SCT through the Cisco WAN Manager application and
saving it with another SCT number. Subsequently, you can assign the new SCT
to the port by the sctID parameter in cnfport.
Note Currently, the system does not support certain parameters in the
SCTs, so you can specify them through addcon, cnfcon, or Cisco
WAN Manager. These parameters are PCR, SCR, and ICR.
ifType Specifies the interface type:
1 = UNI
2 = NNI
3 = Virtual path NNI (VNNI)
vpi Virtual path identifier in the range 1–4095.
Log: log State: active Privilege: GROUP1
