7-28
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 7 SPVC and SVC Commands
cnfconsegep
cnfconsegep
Configure Connection Segment Endpoint
Configures a connection as a segment endpoint. When both VPI and VCI are present, the segment
endpoint is an F5 flow endpoint (for VCCs). When the optional VCI is not present, the segment endpoint
is an F4 flow endpoint (for VPCs). Use this command only for established calls.
Note Before executing this command, be sure continuity checking is de-activated. If you leave it on,
continuity check failure occurs for the connection. Use cnfconsegep in conjunction with conntrace
for fault isolation.
Command(s) on Which Command Executes
PXM45
Syntax
cnfconsegep <portid>
< vpi >
[vci]
Syntax Description
Related Commands
cnfoamsegep, dspoamsegep, delconsegep, dspconsegep
Attributes
portid The portid represents the PNNI physical port and has the format
[shelf.]slot[:subslot].port[:subport]. See also PNNI Format, page 7-4.
vpi VPI of the connection.
vci VCI of the connection.
Log: log State: active Privilege: GROUP1
