Page 7
SKU 93167
For technical questions, please call 1-800-444-3353
Boom Extension (34)
Pin
(42)
Clevis Pin No. 1 (29)
Seat (73)
Hydraulic Fluid
Reservoir
Hydraulic Fluid
Fill Plug (11)
TOW CONFIGURATION
Engine (74)
Frame Assy. (90)
Mount Hitch
Coupler (58)
Here
Control
Panel
(23)
Boom
Pivot (38)
Clevis Pin
No. 1 (29)
Main
Boom
(36)
Pin
(42)
3. Lower the Trencher and remove the
jack stands. Block the tires while
you tighten the Lug Nuts. NOTE:
Make sure to tighten (torque) the
Lug Nuts to at least 90 Ft.-Lbs.
4. Place the Seat (73) onto the tube at
the top of the Hydraulic Fluid Reser-
voir. Attach the Control Support (3)
to the Frame Assembly (90) using
four Hex Bolts (72). See illustration
at bottom of page.
NOTE: The Hydraulics of this unit are
tested before shipment. There is
ASSEMBLY
1. With the help of one or more assistants, use jacks (not included) to evenly raise the
Frame Assembly (90) & support with jack stands (not supplied). Then mount both Axles
and Hub Assembly (50) near the boom end of the frame, as shown at bottom. Secure
with Lock Pins (20).
2. Place a Tire (52) over the four studs on each Hub. Secure the Tires to the Hubs, using
four Lug Nuts (53) per Tire. Make sure that the lug nuts are snug and centered in the
holes. Inflate the tires to 65 PSI.
hydraulic fluid present in many components. Assemble
this unit in an area that will not be damaged by leaking
hydraulic fluid and it is recommended that you wrap rags
securely over the Hydraulic connectors on all the Cylin-
ders (26) during assembly. Always wear splash-resistant
ANSI approved safety goggles and other protective gear
to prevent injury from leaking fluid.
5. Attach the Main Boom (36) to the Boom Pivot (38) using Pin
(42) through the bottom hole and Clevis Pin No. 1 (29) through
the upper hole. Secure both pins with Hair Pins (31); Pin (42)
requires one Hair pin on each end. See photo below. Other
people will need to assist in the process.
REV 05j; 07f
