Page 10
SKU 93167
For technical questions, please call 1-800-444-3353
TRANSPORT
Locking the Boom in Place
1: a. Use the Bucket Lever to line the hole on the Bucket Assembly (32) up with the hole on
the Boom Extension (34). Insert a Safety Locking Pin (15) and secure with a Hairpin
Clip (31).
b. Use the Boom Swing Lever to line up the hole in the Boom Pivot (38) with the Hole in
the Frame (90). Insert a Safety Locking Pin (15) and secure with a Hairpin Clip (51).
c. Put the Boom into the Shallow Position (see
page 15) and raise it until the pin on the side of
the Main Boom (36) is close enough for the
Safety Latch (41) to swing over it. To use
the Safety Latch, pull out on the handle,
swing it over the pin, and lower it
over the pin, locking it in place.
2. When transporting the Tren-
cher, make sure your hitch
(not included) is compat-
ible with the Hitch Coupler
(58). Follow all of the safety
warnings for towing in your
vehicle’s manual.
WARNING: The Hitch Coupler will only accept a 2
inch hitch ball.
3. To reduce friction between the hitch ball and Hitch
Coupler (58), apply a layer of heavy weight grease
over the hitch ball.
4. See illustration below. Temporarily remove the “R” Pin and Safety Pin. Then, pull up
on the Trigger and lift up on the Handle.
Safety Latch (41)
Safety Locking Pins (15)
REV 07f
