Filter
Top Products
20
b. If the walking belt slips when walked on,rst
remove the key and UNPLUG THE POWER
CORD. Using the hex key, turn both idler roller
screws clockwise, 1/4 of a turn. When the walk-
ing belt is correctly tightened, you should be able
to lift each edge of the walking belt 2 to 3 in. (5 to
7 cm) off the walking platform. Be careful to keep
the walking belt centered. Then, plug in the power
cord, insert the key, and carefully walk on the
treadmill for a few minutes. Repeat until the walk-
ing belt is properly tightened.
SYMPTOM: The upperbody arms squeak during
use
a. (Note: Correcting this problem requires a small
amount of white marine grease, available at
hardware stores.) Turn the Resistance Knob (A)
counterclockwise and remove it. Next, remove
the Resistance Cone (B) and the Left Upper
Body Arm (105), along with the Resistance Plate
(C), Washers (D), Spring Washer (E), Thrust
Washers (F), and Thrust Bearing (G). (Note: If the
Resistance Plate [C] comes out of the Resistance
Cone [B], press it back in.) Apply a thin layer of
white marine grease to the outer surface of the
Resistance Cone (B). Then, reattach all parts in the
order shown below.
B
105
A
F
E
C
G
D
b
a