Filter
Top Products
8
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. In order to adjust the
reed switch, the Left Side Shield (10) must be remov-
ed. Using an adjustable wrench, turn the Left Pedal
(8) clockwise and remove it from the Crank (22).
Remove the three Side Shield Screws (40) from the
Right Side Shield (11) and the two M4 x 16mm
Screws (46) from the Left Side Shield (10). Make sure
that the arm of the Crank (22) is in the position shown
in the drawing. Carefully slide the Left Side Shield
(11) forward off the arm of the Crank and remove it.
Next, locate the Reed Switch (49). Turn the Crank
(22) until the Magnet (4) is aligned with the Reed
Switch. Loosen but do not remove the M4 x 16mm
Screw (46). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console dis-
plays correct feedback. When the Reed Switch is cor-
rectly adjusted, reattach the left side shield and pedal.
HOW TO ADJUST THE RESISTANCE STRAP
If there is not enough pedaling resistance when the
resistance knob is turned to the highest setting, the
Resistance Strap (15) may need to be adjusted. To
adjust the Resistance Strap, the left side shield must
first be removed. Refer to the instructions on page 7
and remove the left side shield.
Next, turn the
resistance knob to
the lowest setting.
Locate and open
the Strap Clamp
(38). Grip the end
of the Resistance
Strap (15) and pull
it up slightly. While
holding the end of
the Resistance
Strap, fully close
the Strap Clamp. Turn the Crank (22) for a moment to
make sure that there is not too much resistance.
When the Resistance Strap is properly adjusted, reat-
tach the left side shield and pedal.
HOW TO ADJUST THE DRIVE BELT
The exercise
cycle features a
drive belt that
must be kept
properly adjust-
ed. If the belt
causes exces-
sive noise or
slips as you
pedal, the belt
should be
checked. To do
this, the side shields must first be removed. Refer to
the instructions on page 7 and remove the left side
shield. Next, remove the right side shield in the same
way.
Press down on
the center of the
Drive Belt (14)
between the front
and rear pulleys.
There should be
from 1/4” to
1/2” of move-
ment in the cen-
ter of the Belt. If
the Drive Belt
(14) is properly
adjusted, reat-
tach the side shields and pedals. If the Belt needs to
be adjusted, loosen the Nylon Locknut (36) on the left
side of the Flywheel (29). To tighten the Belt, turn the
Adjustment Bolt (31) clockwise; to loosen the Belt,
turn the Adjustment Bolt counterclockwise. Make sure
that the Flywheel is straight and tighten the Nylon
Locknut (36). Reattach the side shields and pedals.
22
29
14
Top View
Top View
14
36
31
38
15
10
22
11
46
8
40
40
22
49
46
4