Filter
Top Products
4. Remove the console back and the four M4.2 x
12mm Screws (3) from the Console (80). Save
the console back and the Screws for step 6.
Hold the Console (80) near the Console Plate
(81). Touch the Console Plate to discharge
any static.
Next, press the connector on the end of the
Wire Harness (84) into the connector on the
back of the Console (80) in the location shown.
See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn the connector on the
Wire Harness and try again. IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON.
4
8
Connector
80
84
81
84
Connectors
3. Attach the Console Plate (81) to the Handrail
Crossbar (83) with two M8 x 16mm Bolts (1) and
t
wo M8 Star Washers (5). Make sure the
Console Plate is oriented as shown and that
t
he Wire Harness (84) is not pinched.
Remove the wire tie from the Wire Harness (84).
3
83
81
1
1
Wire Tie
84
5
5
Console
Back
3
3