Filter
Top Products
9
9
9. Set the Console (2) on the Console Base (45). Insert the
excess Wire Harness (53) into the large hole in the side of
the Right Handrail (5). Securely tighten the plastic ties
on the bottom of the Console Base to prevent the Wire
Harness from slipping. Then, cut off the ends of the plas-
tic ties.
Attach the Console (2) to the Console Base (45) with four
3/4” Screws (77) and two 1/2” Screws (92). Start all six
Screws before tightening them; do not overtighten
the Screws.
77
92
5
77
45
53
2
Ties
8
8. Hold the Console (2) near the Console Base (45). Touch
the Right Handrail (5) to discharge any static. Find
t
he connector on the end of the Wire Harness (53).
Insert the connector into the red socket beneath the
C
onsole. T
he connector should slide easily into the
socket and snap into place. If the connector does
not slide easily and snap into place, turn the connec-
tor and then insert it.
Make sure that the connector and
wires appear as shown in drawing 8a.
See drawing 6a. Insert the excess Wire Harness (53)
down into the opening in the Console Base (45).
Securely tighten the plastic tie on top of the Console
Base to prevent the Wire Harness from slipping.
Then, cut off the end of the plastic tie.
8a
2
53
T
ies
53
5
45
10.Lower the Uprights (32, 37) until the Handrails (4, 5) are
touching the floor.
See drawing 10a. Position the Uprights (32, 37) so that
the treadmill Frame (21) is centred between the
Uprights.
Firmly tighten the four Upright Bolts (28). Then, raise the
Uprights (32, 37) back to the vertical position.
Firmly tighten the bolts and screws used in assem-
bly steps 3 through 6.
37
32, 37
4, 5
21
21
32
Top View
10
10a
28