Filter
Top Products
6
ASSEMBLY
A
ssembly requires two persons. Place a mat under the treadmill to protect the floor during assembly.
S
et
the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until as-
sembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant.
During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton.
This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt,
simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex key and your own phillips screwdriver ,
adjustable spanner , wire cutters , and needlenose pliers .
For help identifying the assembly hardware, see the part drawings below.
WARNING: Do not plug in the power
cord until the treadmill is completely assembled.
2 3/4” Bolt (47 )–4
Wheel Nut
(61)–2
1
3/4” Screw
(77)–10
Upright Bolt (28)–6
Crossbar/Spacer
Screw (86)–4
Silver Ground
Screw (89)–1
1/2” Screw
(92)–2
5/16” Star Washer
(68)–4
3/8” Star Washer
(104)–2
Frame Bolt (36)–2
Wheel Bolt (33)–2
1” Tek Screw
(11)–4
34
34
55
61
61
11
11
11
11
33
33
19
31
31
31
1
1.
Orient the Base (55) so the holes for the four Base Pads
(31) are on top. Attach the four Base Pads to the Base
with the four 1” Tek Screws (11).
Attach the two Wheels (34) to the Base (55) with two
Wheel Bolts (33) and two Wheel Nuts (61) as shown. Do
not overtighten the Bolts. The Wheels must be able
to turn freely.