Filter
Top Products
4. Identify the Right Handrail (5), which has a large hole in
the left side. Feed the Wire Harness (53) into the hole in
the bottom of the Right Handrail and out of the large hole
in the side. Note: It may be helpful to use needlenose pli-
ers to pull the Wire Harness out of the hole.
Set the Right Handrail (5) onto the right Upright (37).
Attach the Right Handrail with a Upright Bolt (28) as
shown. Firmly tighten the Upright Bolt.
Attach the Left Handrail (4) as described above. Note:
There is not a wire harness on the left side.
53
Hole
28
5
28
4
32
37
4
36
37
21
3. With the help of a second person, place the Frame (21)
between the Uprights (32, 37). Feed the Wire Harness
(53) into the large round hole near the lower end of the
Right Upright (37), and then pull the Wire Harness out of
the upper end as shown.
See drawing 3a. Raise the Uprights (32, 37) to the vertical
position. Hold an Upright Spacer (58) against one side of
the Frame (21) as shown. Insert a Frame Bolt (36) into the
indicated hole in the Upright Spacer and the Frame. Next,
tighten a Spacer Screw (86) into the Upright Spacer and
the Frame. Remove the Frame Bolt. Repeat on the other
side of the Frame.
With the help of a second person, carefully lift the Frame
(21), and hold the Upright Spacers (58) between the Right
Upright (37) and the Left Upright (not shown). Align the in-
dicated hole in the Right Upright with the hole in the right
Upright Spacer. Next, insert a Frame Bolt (36), with a 3/8”
Star Washer (104), into the Right Upright and the Upright
Spacer, and loosely thread the Upright Bolt into the Frame.
Repeat this step on the left side of the treadmill.
58
86
Hole
2. Identify the Right Upright (37), which has a large round
hole near the lower end, and the Left Upright (32).
See drawing 2a. Make sure that there are two U-nuts
(
93) in the lower end of each Upright (32, 37).
See drawing 2b. Have a second person hold the Base
(55) so it is resting on the Wheels (34) as shown. Attach
the Right and Left Uprights (32, 37) to the Base with four
Upright Bolts (28) and four 5/16” Star Washers (68). Do
not tighten the Bolts yet. Make sure that the large
hole in the Right Upright is on the side shown, and
that the two small holes in the Left Upright are on the
side shown. In addition, make sure that the Base is
oriented so the Base Pads (31) are in the location
shown.
9
3
68
68
37
32
Large
Hole
Small
Holes
31
31
34
55
28
28
37
H
ole
2
2a
2b
32, 37
7
3
Holes
104
3a
53
Hole
21
53
37
32