Filter
Top Products
8
7. Tap two 1” Square Inner Caps (35) into each of
the two Backrest Tubes (5).
Attach each Backrest Tube (5) to the Backrest (6)
with two M6 x 38mm Screws (30) and two M6
Washers (26). Note: Do not tighten the Screws
yet.
8. Tap a 3/4” Round Inner Cap (9) into each end of
the Support Rod (7). Insert the Support Rod
through one of the three upper sets of holes in
the Uprights (1). Rotate the Support Rod to the
locked position, with the locking pin wrapped
around the Upright.
Lubricate the M10 x 135mm Bolt (36). Attach the
Backrest Tubes (5) to the welded tube on the
Frame (2) with the Bolt, two M10 Washers (34),
and an M10 Nylon Locknut (33).
Tighten the M6 x 38mm Screws (30) used in
step 7, and the Nylon Locknuts (17, 33) used
in steps 1–3.
9. Attach the Seat (11) to the brackets on the Frame
(2) with four M6 x 16mm Screws (29) and four M6
Washers (26).
10. Tap a 30mm Square Inner Cap (22) into each end
of a Fly Arm (25). Push a 1” Round Inner Cap
(24) into the end of the weight tube. Slide a
Weight Stop (28) onto the weight tube.
Assemble the other Fly Arm (not shown) in the
same manner.
7
5
30
26
26
30
6
8
9
10
35
35
9
9
11
29
29
28
24
22
Weight Tube
22
25
2
34
5
36
7
1
2
Welded Tube
1
33
26
26
34