Filter
Top Products
7
1. Make sure that the power cord is unplugged.
A
ttach a Wheel (95) to each side of the Base
(37) with a Wheel Bolt (4), two Wheel Spacers
(
94), and a Nut (12) as shown.
D
o not over-
tighten the Wheel Bolts; the Wheels should
turn freely.
Identify the Right Upright (39), which has a
square hole in the location shown.
Orient the Right Upright (39) and the Base (37)
as shown. Attach the Right Upright to the Base
with two Upright Bolts (4) and two Upright Star
Washers (6);
do not tighten the Upright Bolts
yet.
4
6
39
3. With the help of a second person, raise the
Uprights (38, 39) so the Base (37) is flat on the
floor as shown. Next, position the front of the
treadmill Frame (36) between the Uprights.
See the inset drawing. Locate the wire inside the
lower end of the Right Upright (39). Tie the wire
securely to the end of the Upright Wire (69).
Next, insert the wire and the end of the Upright
Wire into the hole in the Right Upright.
2. Orient the Left Upright (38) as shown, and attach
it to the Base (37) with two Upright Bolts (4) and
two Upright Star Washers (6);
do not tighten
the Upright Bolts yet.
37
38
6
6
Latch
Holes
2
1
Square
Hole
37
36
38
39
3
37
9
5
12
9
4
94
4
95
9
4
94
4
12
4
69
Wire
Wire
69
39