Filter
Top Products
12
16. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra parts may be
included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt
(see page 21). To protect the oor or carpet, place a mat under the treadmill.
15. Orient the Latch Housing (76) so that the
large hole is on the side shown. Attach the
Latch Housing to the Left Upright (77) with two
#8 x 3/4" Screws (7). Do not overtighten the
Screws.
Locate the Latch Pin Assembly (75). Remove
the knob from the pin. Make sure that the collar
and the spring are on the pin as shown. Insert
the pin into the Latch Housing (76), and tighten
the knob back onto the pin.
7
76
77
Large
Hole
15
Knob
Pin
Collar
Spring
13. Lower the Uprights (77, 78) as shown.
See the inset drawing. Position the Uprights
(77, 78) so that the Frame (55) is centered
between the Uprights.
Firmly tighten the 3/8" x 2 1/2" Bolt (1) and then
tighten the 3/8" x 2 1/4" Screws (8) on each side
of the treadmill. Do not overtighten the 3/8" x
2 1/2" Bolts.
78
77, 78
1
55
55
77
View from Above
Side View
13
8
14. Attach the ground wire on the Upright Wire (74)
to the indicated hole in the Base (85) with a #8 x
1/2" Screw (12).
Press the indicated Grommet (21) into the Right
Upright (78).
Raise the Right Upright (78) and the Left Upright
(not shown).
85
74
78
14
12
Ground
Wire
21
Hole
75