Filter
Top Products
11
11. Hold the handrail assembly near the console
assembly. Connect the wire harness extending
from the handrail assembly to the wire har-
ness extending from the console assembly. See
the inset drawing in step 7. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Set the Handrail Bracket (70) in the slot in the
console assembly as you slide the ends of the
Handrails (69, 71) onto the brackets on the
Uprights (77, 78). Be careful not to pinch any
wires.
69
70
Handrail
Assembly
77
78
Slot
Bracket
Console
Assembly
Bracket
11
12. Partially tighten two 1/4" x 1 1/2" Bolts (3)
with two 1/4" Washers (31) and two 1/4" Star
Washers (11) into the Console Frame (92) and
the Handrail Bracket (not shown). Do not fully
tighten the Bolts yet.
Next, partially tighten four 1/4" x 1/2" Screws (6)
with four 1/4" Star Washers (11) into the lower
ends of the Handrails (69, 71).
Press the lower ends of the Handrails (69, 71)
against the Uprights (77, 78) as you tighten the
four 1/4" x 1/2" Screws (6). Then, tighten the
1/4" x 1 1/2" Screws (3).
6
3
78
69
77
71
92
11
12
71
6
11
Wire
Harnesses
11
31
31