Filter
Top Products
9
8. Fold the Incline Trainer to the storage position (see HOW
TO FOLD THE INCLINE TRAINER FOR STORAGE on
page 28).
Slide the Right Wheel Bracket (59) into the slot in the
Right Rear Endcap (57). Align the holes in the Bracket
with the holes in the Frame (43). Attach the Bracket to the
Frame with two 1” Bolts (55).
Attach the Left Wheel Bracket (not shown) in the same
way.
59
57
43
8
55
9. Make sure that all parts are properly tightened before you use the Incline Trainer. Keep the included
allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 31). To protect
the floor or carpet from damage, place a mat under the Incline Trainer.
7. Tighten two 3” Bolts (98) with two Washers (97) into the
bottom of the Upright Base (96) and the Handrails (67)
(
only one Handrail is shown). Firmly tighten the Bolts.
W
ith the help of a second person, carefully tip the Upright
Base (96) so it is flat on the floor. Remove the cardboard
from underneath the Upright Base.
98
9
7
96
98
67
97
7