9
11.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt
(see page 18). To protect the floor or carpet, place a mat under the treadmill.
9. Lower the Handrails (40, 13) until they are touching the
floor.
See drawing 9a. Position the Handrails (40, 13) so the
t
readmill Frame (96) is centered between them.
Firmly tighten the four 3” Bolts (58) and the two 4”
Frame Bolts (54). Be careful not to overtighten the
Bolts.
13
40
40, 13
96
96
Top View
9
9a
58
54
10. Attach the Latch Housing (46) to the Left Upright (47)
with two 3/4” Screws (38). Make sure that the large
hole in the Latch Housing is on the side shown.
Remove the knob from the pin. Make sure that the col-
lar and the spring are on the pin. Insert the pin into the
Latch Housing (46), and then tighten the knob back onto
the pin.
46
38
Pin
Spring
47
Large Hole
Knob
Collar
10