Filter
Top Products
MAINTENANCE AND TROUBLESHOOTmNG
Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies, and follow the steps tisted, mffurther assistance is needed, call toil-free 1-800-4-MY-HOME _;
(1-800-469-4663}.
PROBLEM: The power does not turn on
SOLUTmON: a,
Make sure that the power cord is plugged into a surge suppressor, and that the surge suppres-
sor is plugged into a properly grounded outlet (see page 8), Use only a single-outlet surge sup-
pressor that meets all of the specifications described on page 8, important: The treadmill is not
compatible with GFCI-equipped outlets,
b, After the power cord has been plugged in, make sure that the key is fully inserted into the console,
C, Check the circuit breaker located on the treadmill
frame near the power cord, if the switch pro-
trudes as shown, the circuit breaker has tripped,
To reset the circuit breaker, wait for five minutes
and then press the switch back in,
c
Tripped
Reset
PROBLEM: The power turns off during use
SOLUTION: a, Check the circuit breaker located on the treadmill frame near the power cord (see 1, c, above), if
the circuit breaker has tripped, wait for five minutes and then press the switch back in,
b, Make sure that the power cord is plugged in, if the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in,
c, Remove the key from the console, Reinsert the key fully into the console,
d, if the treadmill still will not run, please call toll-free 1-800-4-MY-HOME _ (1-800-469-4663),
PROBLEM: The displays of the consote do not function property
SOLUTION: a,
Remove the key from the console and UNPLUG THE
POWER CORD. Remove the screws from the hood,
Note each hob the screws are removed from,
Carefully remove the hood, Locate the Reed Switch
(13) and the Magnet (63) on the left side of the Pulley
(75), Turn the Pulley until the Magnet is aligned with
the Reed Switch, Make sure that the gap between
the Magnet and the Reed Switch is about 1/8". if
necessary, loosen the Screw (89), move the Reed
Switch slightly, and then retighten the Screw, Re-
attach the hood, making sure that the screws are
tightened into the original hobs, Run the treadmill for
a few minutes to check for a correct speed reading,
View
m
...... 75
12