Filter
Top Products
33. Route the Low Cable (86) over the lower
3.1/2” Pulley (15) attached to the “I”-Plates
(81). The Cable must be routed from the
direction shown.
34. Slide a 5/16” Washer (8) onto a 5/16” x 3” Bolt
(93). Insert the Bolt into the Front Base (4).
Slide theend of the Press Cable (88) onto the
Bolt. Fully tighten a 5/16” Nylon Locknut (3)
onto the Bolt. Do not overtighten the Nylon
Locknut.
35. Attach the Small “U”-Bracket (67) to the indi-
cated Weight Tube (63) a the 5/16” x 1 3/4”
Bolt (72) and a 5/16” Nylon Locknut (3).
36. Locate the Rear Cable (95). Attach the Rear
Cable to the Rear Base (51) with the 3/8” x
3/4” Bolt (24) and a 3/8” Nylon Locknut (21).
Route the Rear Cable (95) over the 3 1/2”
Pulley (15) attached to the Long “U”-Bracket
(57).
36
16
CABLE ASSEMBLY
33
34
93
15
86
86
81
8
4
3
35
67
63
3
72
24
51
15
57
95
21