Filter
Top Products
23. Attach the High Cable (23) to a Small “U”-
Bracket (67) with a 1/4” Nylon Locknut (2)
and a 1/4” Washer (10). Do not completely
tighten the Nylon Locknut. It should be
threaded onto the end of the Cable only a
couple of turns, as shown in the inset
drawing.
24. Locate the Press Cable (58). Attach the
Press Cable to the Rear Upright (56) with a
5/16” x 3” Bolt (93), a 5/16” Washer (8), and
two 5/16” Nylon Jam Nuts (84). The end of
the Cable must be between the two Nylon
Jam Nuts and there must be enough room
between the Nylon Jam Nuts for the end
of the Cable to pivot.
Wrap the Press Cable (58) around a 3 1/2”
Pulley (15). Attach the Pulley and a Cable
Trap (66) to the Squat Arm (79) with a 3/8” x
3 3/4” Bolt (71), a 3/8” Washer (9), and a 3/8”
Nylon Locknut (21). The Cable Trap must be
turned to hold the Cable in place.
25. Attach the end of the Press Cable (58) to the
Long “U”-Bracket (57) with a 1/4” Nylon Lock-
nut (2) and a 1/4” Washer (10). Do not com-
pletely tighten the Nylon Locknut. It
should be threaded onto the end of the
Cable so only a couple of threads are
showing above the nut, as shown in the
inset drawing.
25
CABLE ASSEMBLY
13
57
10
2
58
58
57
2
10
23
24
23
67
10
2
71
66
15
58
84
93
8
9
21
79
56
23
67
2
10