Filter
Top Products
17
40. Note: The 3 1/2” Pulley (82) used in this
step was attached in step 38. It is shown
r
emoved for easier part identification.
R
oute the Press Cable (88) around the 3 1/2”
Pulley (82).
Be sure that the Cable Trap (80)
is turned to hold the Cable in place and
that the Cable is routed as shown. Tighten
the 3/8” x 5” Bolt (74) and the 3/8” Nylon
Locknut (42).
41. Slide a 5/16” Washer (20) onto a 5/16” x 2 3/4”
Bolt (55). Insert the Bolt into the Front Seat
Frame (8). Fully tighten a 5/16” Nylon Jam
Nut (91) onto the Bolt. Slide the end of the
Press Cable (88) onto the Bolt.
Thread anoth-
er 5/16” Nylon Jam Nut onto the Bolt,
but do
not fully tighten it. Leave enough room
between the two Jam Nuts for the Cable to
pivot.
42. Identify the High Cable (85)—this is the
shortest remaining cable. Wrap the High
Cable around a 3 1/2” Pulley (82). Attach the
Pulley to the Top Frame (2) with a 3/8” x 3 3/4”
Bolt (76), a 3/8” Washer (38), and a 3/8”
Nylon Locknut (42). Be sure that the end of
the Cable with the ball is on the indicated
side of the Pulley and that the Cable is
between the Pulley and the post.
43.
W
rap the High Cable (85) around a 3 1/2”
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the Top Frame (2) with a 3/8” x
3 3/4”
Bolt (76), a 3/8” W
asher (38), and a
3/8” Nylon Jam Nut (43). Be sure that the
Cable T
rap is positioned to hold the Cable
in place.
43
41
42
CABLE ASSEMBLY
42
38
2
76
82
85
Post
85
80
38
76
2
82
43
40
9
82
42
80
88
91
8
88
20
55
74