Filter
Top Products
11
18. Press a 1 3/4” Square Inner Cap (48) into the
lower end of the Left Fly Arm (6). Wet the
l
ower end of the Left Fly Arm with soapy
water. Slide a 10” Pad (22) onto the Left Arm.
Repeat this step with the Right Fly Arm (5).
19.
Locate and open the parts bags labeled
“CABLE ASSEMBLY” and “PULLEYS.”
During steps 19 through 50, refer to the
CABLE DIAGRAMS on pages 26 and 27 of
this manual to verify proper cable routing.
Before beginning this section, fully unwind the
five Cables and identify the Cables by com-
paring the lengths and the ends. The approxi-
mate length of each Cable, in inches, is listed
after the key number in the drawing.
IMPORTANT: While assembling the cables,
do not overtighten the bolts and nuts
attaching the pulleys. The pulleys must be
able to turn freely.
20. Insert a 5/16” x 1” Bolt (51) through the brack-
et on the Right Fly
Arm (5).
T
ighten a 5/16”
Nylon Jam Nut (91) onto the Bolt.
Identify the Butterfly Cable (89)—this is the
second shortest Cable. Slide one end of the
Butterfly Cable onto the 5/16” x 1” Bolt (51).
Thread another 5/16” Nylon Jam Nut (91)
onto the Bolt, but do not fully tighten it.
Leave enough room between the two Jam
Nuts for the Cable to pivot.
20
18
19
CABLE ASSEMBLY ARM ASSEMBLY
5
6
4
8
22
88—239”
51
5
91
89
22
86—110”
85—101”
89—82”
87—72”