Filter
Top Products
4
ASSEMBLY
1
8
8
11
51
27
1
4
3
1
51
5
1. Before beginning assembly, be sure that
you have read and understand the infor-
mation in the box above.
Locate and open the parts bag labeled
“FRAME ASSEMBLY.”
Press two 50mm Square Outer Caps (51)
onto the Stabilizer (5). Press a 50mm
Square Inner Cap (27) into the Base (4).
Insert six M8 x 65mm Carriage Bolts (1) up
through the Stabilizer (5). Insert two M8 x
65mm Carriage Bolts up through the Base
(4).
Attach the Base (4) to the Stabilizer (5) with
two M8 x 70mm Bolts (11), two M8 Washers
(8), and two M8 Nylon Locknuts (3). Do not
tighten the Nylon Locknuts yet.
FRAME ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts of the weight system in a cleared
area and remove the packing materials; do not
dispose of the packing materials until assembly is
completed.
• The assembly is broken into four stages: 1) frame
assembly, 2) arm assembly, 3) cable assembly,
and 4) seat and backrest assembly. The hard-
ware for each stage is packaged separately.
•Wait until you begin each assembly stage to open
the parts bag labeled for that assembly stage.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART located in the center of this manual.
Note: Some small parts may have been pre-
attached for shipping. If a part is not in the parts
bag, check to see if it has been pre-attached.
• As you assemble the weight system be sure that
all parts are oriented as shown in the drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
•Two (2) adjustable wrenches
• One (1) standard screwdriver
• One (1) phillips screwdriver
• One (1) rubber mallet
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
1