Filter
Top Products
17
36. Slide an M8 Washer (8) onto an M8 x 75mm
Bolt (93). Insert the Bolt through the indicated
hole in the Pivot Arm (101). The Bolt must
be inserted from the side shown. Fully tight-
en an M8 Nylon Locknut (3) onto the Bolt.
Wrap the Military Press Cable (72) around a
90mm Pulley (15). Attach the Pulley and a
Cable Trap (66) to the Pivot Arm (101) with
the M10 x 95mm Bolt (88), an M10 Washer
(9), and an M10 Nylon Locknut (21). Be sure
that the Pulley is on the side shown and
that the Cable Trap is positioned to hold
the Cable in place.
37. See inset drawing A. Attach a 90mm Pulley
(15) and a Cable Trap (66) to the upper hole
in a Long “U”-Bracket (57) with an M10 x
50mm Bolt (12) and an M10 Nylon Locknut
(21). Be sure that the Cable Trap is inside
the Long “U”-Bracket. Note: This may
come pre-assembled.
Route the Military Press Cable (72) through
the Long “U”-Bracket (57) and around the
90mm Pulley (15). Be sure that the Cable is
in the groove of the Pulley and that the
Cable and Pulley move smoothly.
See inset drawing B. Slide the end of the
Military Press Cable (72) onto the end of the
indicated M8 x 75mm Bolt (93). Thread anoth-
er M8 Nylon Locknut (3) onto the Bolt. Do not
fully tighten the second Locknut. There
must be room between the two Locknuts
for the end of the Cable to pivot.
37
CABLE ASSEMBLY
72
15
21
57
A
B
12
15
66
57
3
72
36
88
93
72
21
66
101
15
9
3
8
93