Filter
Top Products
26
5
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight system, make sure
all parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
An Allen wrench (included) and the following
tools (not included) are required for assembly:
• two adjustable wrenches
• one rubber mallet
• one standard screwdriver
• one Phillips screwdriver
• lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight system can be assembled suc-
cessfully by anyone. However, it is important to
realize that the versatile weight system has
many parts and that the assembly process will
take time. Most people find that by setting aside
plenty of time, assembly will go smoothly.
ASSEMBLY
1
33
33
60
67
68
98
1
71
60
67
28
26
26
57
57
1. Before beginning, make sure that you under-
stand the information in the box above.
Attach the Base Cap (28) to the Right Base (1)
with two #8 x 3/4” Screws (68).
Attach the Center Base (67) to the Right Base (1)
with two 5/16” x 2 3/4” Bolts (60), two 5/16”
Washers (26), and two 5/16” Nylon Locknuts (71).
Insert four 5/16” x 2 1/2” Carriage Bolts (57) up
into the Right Base (1). Tape the bolt heads in
place.
FRAME ASSEMBLY
2. Press two 2” Square Inner Caps (33) into the
ends of the Left Base (2). Attach the Rubber
Bumper (98) to the Left Base with a #8 x 3/4”
Screw (68).
Insert four 5/16” x 2 1/2” Carriage Bolts (57) up
into the Left Base (2). Tape the bolt heads in
place.
Attach the Left Base (2) to the Right Base (1) and
the Center Base (67) with three 5/16” x 2 3/4”
Bolts (60), three 5/16” Washers (26), and three
5/16” Nylon Locknuts (71).
2
1
2
60
71
57
68
26
57