Filter
Top Products
16
39. Route the Low Cable (47) through the Left Leg
(36) and the Left Upright (7). Attach a 3 1/2”
Pulley (38) inside the Upright with a 3/8” x 2 3/4”
Bolt (81), two 3/8” Washers (75), two 1/2”
Spacers (34), and a 3/8” Nylon Locknut (70).
40. Wrap the Low Cable (47) around a 3 1/2” Pulley
(38). Attach the Pulley and a Cable Trap (91) to
the lower set of holes in the indicated “U”-Bracket
(85) with a 3/8” x 2” Bolt (62) and a 3/8” Nylon
Locknut (70). Be sure the Cable Trap is turned
to hold the Cable in the groove of the Pulley.
38. Locate the Low Cable (47). Route the small ball
on the Cable through the cage on the Leg Press
Frame (30).
Attach a 3 1/2” Pulley (38) inside the Leg Press
Frame (30) with a 3/8” x 2 3/4” Bolt (81), two 3/8”
Washers (75), two 1/2” Spacers (34), and a 3/8”
Nylon Locknut (70).
37. Remove the preattached 3 1/2” Pulley (not
shown) from the “U”-Bracket (85).
Attach the end of the Leg Lever Cable (96) to the
other “U”-Bracket (85) with a 1/4” Washer (35)
and a 1/4” Nylon Locknut (65). Note: Do not
completely tighten the Nylon Locknut; it
should be threaded only two turns onto the
end of the Cable, as shown in the inset draw-
ing.
65
35
85
96
37
30
70
75
Cage
47
81
38
34
34
38
34
34
75
75
70
7
36
38
47
81
39
38
47
91
85
70
62
40
96
65
75