Filter
Top Products
19. Route the Short Cable (23) around two “V”-
Pulleys (6). Attach the Pulleys and two Long
Cable Traps (50) to the Left Arm (47) and the
Right Arm (48) as shown, using two 3/8” x
2 1/2” Bolts (7) and two 3/8” Nylon Locknuts
(21). Do not overtighten the Nylon
Locknuts; the Pulleys must be able to turn
freely.
20. Remove the 1/2” Nylon Locknut (81) from the
rod on the Top Frame (55). Attach the Pulley
Bracket (20) to the rod on the Top Frame with
the 1/2” Nylon Locknut. Route the Short
Cable (23) through the Pulley Bracket as
shown. Do not overtighten the Nylon
Locknut; the Pulley Bracket must be able
to pivot freely.
21. Loop the Short Cable (23) as shown. Route
the Short Cable up through the hole in the
Top Frame (55).
Open the bag marked “Pro-Pulley”. Remove
the 4 1/2” Pulley (74). Route the Short Cable
(23) over the Pulley and insert the Pulley into
the hole in the Top Frame (55). Attach the
Pulley using a 3/8” x 3 1/4” Bolt (8), two 3/8”
Washers (9), two 5/8” x 3/4” Spacers (40), and
a 3/8” Nylon Locknut (21) as shown. Do not
overtighten the Nylon Locknut; the Pulley
must be able to turn freely.
22. Attach the end of the Short Cable (23) to the
“U” Bracket (57) with a 1/4” Washer (78) and
a 1/4” Nylon Locknut (2).
Attach the “U” Bracket (57) to the Weight
Tube (63) using a 5/16” x 1 3/4” Bolt (86) and
a 5/16” Nylon Locknut (3).
21
22
19
7
47
48
6
21
50
23
20
13
23
74
21
40
40
23
57
86
63
8
Loop
9
9
CABLE ASSEMBLY
20
Rod
81
23
55
55
78
3
2