Filter
Top Products
15
27
26
11
11. Attach the Curl Pad (27) to the Curl Post (26) with
two M6 x 16mm Screws (15).
12. Slide the Curl Post (26) into the Front Leg (8).
Align one of the adjustment holes in the Curl Post
with the adjustment hole in the Front Leg. Tighten
the M10 x 48mm Adjustment Knob (33) into the
adjustment hole in the Front Leg. Make sure that
you fully tighten the Adjustment Knob.
26
8
33
12
9
13. Tap two 3/4” Round Inner Caps (9) into each Pad
Tube (10). Insert the Pad Tubes into the holes in
the Leg Lever (4) and the Front Leg (8). Slide two
Foam Pads (22) onto each Pad Tube.
14. Make sure that all parts are properly tightened
before you use the weight bench. The use of
all remaining parts will be explained in ADJUST-
MENTS, beginning on page 10.
10
10
9
22
22
4
8
22
10
9
9
9
13