Filter
Top Products
8
9. Lubricate the M10 x 178mm Bolt (17). Attach the
Backrest (6) to the Frame (2) with the Bolt, two
M10 Washers (24), and an M10 Nylon Locknut
(19).
Secure the Backrest (6) by sliding the Adjustment
Pin (32) through one of the three sets of holes in
the adjustment tubes and the indicated hole in the
Frame (2). Secure the Adjustment Pin with the
Pin Clip (14).
Make sure the Adjustment Pin (32) is com-
pletely inserted through both holes in the
adjustment tubes and the Frame (2).
10. With the wide end of the Seat (11) positioned as
shown, attach the Seat to the brackets on the
Frame (2) with four M6 x 16mm Screws (15).
2
32
17
19
14
24
24
Lubricate
Adjustment
Tubes
6
9
2
11
Wide
End
15
10
16
25
42
5
Adjustment
Tubes
12
12
16
16
36
6
Wide
End
8
25
25
8. Press four 1” Square Inner Caps (12) into the
indicated ends of the Backrest Tubes (5, 42).
Press two 1” x 2” Inner Caps (36) into the ends of
the adjustment tubes.
With the wide end of the Backrest (6) positioned
as shown, attach the Backrest Tubes (5, 42) to
the Backrest with four M6 x 38mm Screws (16)
and four M6 Washers (25). Note: The Backrest
Tubes and Backrest must be oriented exactly
as shown.
4
41
38
39
38
37
13
19
Lubricate
40
8
7
7. Lubricate an M10 x 72mm Bolt (40). Attach the
Leg Lever (4) to the Front Leg (8) with the Bolt
and an M10 Nylon Locknut (19).
Attach the Weight Tube (41) to the Leg Lever (4)
with the M8 x 58mm Bolt (39), two M8 Washers
(38), the Spacer (37), and an M8 Nylon Locknut
(13). Note: The Spacer will fit tightly inside of
the Leg Lever.