Filter
Top Products
®
3
19
19
20
35
35
20
19
19
20
35
35
43
3
43
20
Warning Decal
WEIDER
®
PRO
800 Decal
7
30
30
7
1
1
5. Attach the Front Leg (8) to the Frame (2) with two
M10 x 65mm Bolts (18), two M10 Washers (24),
and two M10 Nylon Locknuts (19).
6. Tap three 45mm Square Inner Caps (21) into the
ends of the Leg Lever (4) as shown.
Insert the Weight Tube (41) into the indicated
hole in the Leg Lever (4). Tap a 1” Round Inner
Cap (23) into the indicated end of the Weight
Tube. Press a 1” Angle Cap (29) onto the other
end of the Weight Tube.
7
5
18
24
24
2
19
8
19
21
21
21
41
4
29
23
6
®
4
3
19
2
40
4. Attach the Frame (2) to the Crossbar (3) with two
M10 x 72mm Bolts (40) and two M10 Nylon
Locknuts (19).
3. Note: The following drawings show the
Crossbar (3) adjusted to the standard width.
Note the position of the warning decal and the
WEIDER
®
PRO 800 decal, and make sure that
the Extension Tubes (43) and Upright Bases (7)
are oriented exactly as shown. Attach the
Extension Tubes to the Upright Bases with four
M10 x 81mm Bolts (35), two Support Plates (20),
and four M10 Nylon Locknuts (19).
Slide the Uprights (1) into the Upright Bases (7)
and secure them at the desired height with the
M10 x 67mm Adjustment Knobs (30).
WARNING: Always set both
Uprights (1) at the same height. Make sure
that the M10 x 67mm Adjustment Knobs (30)
are inserted completely and tightened into the
Uprights before you begin any exercise.