Filter
Top Products
8
2
11
Wide End
37
37
77. Orient the Seat (11) with the wide end on the side
shown. Attach the Seat to the Frame (2) with four
M6 x 16mm Screws (37).
9
22
42
43
22
15
27
28
43
44
30
22
36
Lubricate
45
1
6
6. Press three 45mm Square Inner Caps (22) into the
Leg Lever (9). Press a 1” Round Inner Cap (27)
into the indicated end of the Weight Tube (15).
Attach the Weight Tube (15) to the Leg Lever (9)
with the M8 x 58mm Bolt (42), two M8 Washers
(43), the Spacer (30), and an M8 Nylon Locknut
(44). Press the 1” Angled Cap (28) onto the back
of the Weight Tube.
Lubricate an M10 x 72mm Bolt (45). Attach the
Leg Lever (9) to the Front Leg (1) with the Bolt
and an M10 Nylon Locknut (36). Do not over-
tighten the Nylon Locknut; the Leg Lever
must be able to pivot easily.
5. Lubricate the M10 x 178m Bolt (46). Attach the
Right and Left Backrest Frames (7, 8) to the
Frame (2) with the Bolt, two M10 Washers (41),
and an M10 Nylon Locknut (36).
Align an adjustment hole in the Right and Left
Backrest Frames (7, 8) with the indicated hole in
the Frame (2). Insert the Backrest Pin (26)
through the Frame and the Backrest Frames, and
secure it with the Spring Clip (25).
Tighten all of the M10 Nylon Locknuts (36)
used in steps 1–3. Tighten the four M6 x
38mm Screws (39) used in step 4.
5
46
Lubricate
41
8
7
26
36
2
41
25