Filter
Top Products
13
17. Attach the Center Upright (29) to the Rear Base
(25) with the two M10 x 70mm Bolts (116) and
t
wo M10 Nylon Locknuts (94). D
o not tighten
the Nylon Locknuts yet.
18. Identify the Rubber Carriage Stop (133) and the
Metal Carriage Stop (132). Then, slide the
Rubber Carriage Stop onto the Rear Upright (30).
Attach the Rubber Carriage Stop (133) to the
Rear Upright (30) with an M10 x 81mm Bolt
(100), two M10 Washers (96), and an M10 Nylon
Locknut (94).
See the inset drawing. Orient the Weight Carriage
(55) with the notch at the top as shown, and then
slide the Weight Carriage onto the Rear Upright
(30). Next, slide a Carriage Bumper (85) and the
Metal Carriage Stop (132) onto the Rear Upright.
Attach the Metal Carriage Stop (132) to the Rear
Upright (30) with an M10 x 75mm Bolt (125), two
M10 Washers (96), and an M10 Nylon Locknut
(94).
Attach the Rear Upright (30) to the Rear Base
(25) with an M10 x 65mm Bolt (124), two M10
W
ashers (96), and an M10 Nylon Locknut (94).
Do not tighten the Nylon Locknuts yet.
17
18
29
25
116
94
94
94
94
25
96
96
30
96
94
96
85
55
124
125
132
100
133
55
Notch