Filter
Top Products
12
27. Slide the four Foam Pads (26) onto the tubes on
the Front Leg (6) and the Leg Lever (7). Press
four 1 1/4” Round Inner Caps (78) into the ends
of the tubes.
28.
Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the resistance system, pull the long cable a few times to be sure that it moves smoothly over
the pulleys. If the cable does not move smoothly, find and correct the problem. IMPORTANT: If the cables
are not properly installed, they may be damaged when heavy resistance is used. See the CABLE
DIAGRAM on page 16 for proper cable routing.
27
26
78
78
26
7
6
26
26
26. Locate the two Short Cables (33). Wrap one of
the Cables around a 90mm Pulley (28). Attach
the Pulley to a High Pulley Housing (21) with a
3/8” x 1 1/2” Button Head Bolt (71) and a 3/8”
Nylon Jamnut (103).
Repeat this step with the other Short Cable
(33).
26
103
71
21
28
33
25. Attach a 90mm Pulley (28) inside of the hole in
the Front Leg (6) with a 3/8” x 3 3/4” Bolt (90),
two 3/8” x 1” Spacers (52), two 3/8” Washers
(75), and a 3/8” Nylon Jamnut (103).
Make sure
the Pulley is above the Leg Lever Cable (32).
Slide the two free ends of the Leg Lever Cable
(32) onto the hook welded to the bottom of the
Bench Rail (5).
24
25
76
32
6
6
3
7
75
75
90
6
52
28
32
Hook
5
24. Locate the Leg Lever Cable (32), which has two
ends that are the same length and a third end
t
hat is longer.
R
oute the longest end of the Leg Lever Cable
(32) through the hole in the Front Leg (6), and
attach it inside of the hole in the Leg Lever (7)
with a 3/8” x 2 1/4” Button Head Bolt (63) and a
3/8” Nylon Locknut (76).
103
52