Filter
Top Products
16
35
75
46
48
48
63
35. Attach the loop on the end of the Low Pulley Cable
(75) to the indicated hole in the Small Leg Lever (41)
with a 3/8” x 2 3/4” Bolt (46), two 3/8” Flat Washers
(48), and a 3/8” Nylon Jamnut (63).
36. Remove a Pro Pulley (26) from the bag labeled
“PULLEY BAG 2.
Identify the Press Cable (72). It is approximately 389
1/2” long and it has a ball on one end and a threaded
shaft on the other. You will begin by attaching the end
with the ball.
Wrap the Press Cable (72) around a Pro Pulley (26) in
the direction shown. Attach the Pulley to the indicated
hole in the Press Top Frame (9) with a 3/8” x 3 1/2”
Bolt (56), a 3/8” Flat Washer (48), and a 3/8” Nylon
Jamnut (63). Make sure the Cable is between the
Pulley and the welded pin on the Press Top Frame.
37
9
24
72
37. Route the threaded end of the Press Cable (72)
around the 3 1/2” Pulley (24) that is already mounted
on the Top Frame (9).
38
25
72
2
59
50
24
38. Wrap the Press Cable (72) around a 3 1/2” Pulley (24)
in the direction shown. Attach the Pulley to the indicat-
ed hole in the Press Upright (2) with a 3/8” x 3 3/4”
Bolt (59), a 3/8” Flat Washer (48) and a 3/8” Nylon
Locknut (50). Make sure the Cable Trap is oriented
as shown.
36
Pin
9
56
72
48
63
26
41
48