Filter
Top Products
14
29. Wrap the Ab Cable (74) around a 4 1/2” Pulley (82) in
the direction shown. Attach the Pulley inside the indi-
cated bracket on the Weight Top Frame (66) with a
3/8” x 1 3/4” Bolt (57) and a 3/8” Nylon Locknut (50).
Make sure the threaded end of the Ab Cable is
routed through the bracket, as shown.
28. Wrap the Ab Cable (74) around a 3 1/2” Pulley (24) in
the direction shown. Slide the Pulley and a Cable
Trap (25) onto the 3/8” x 3 1/2” Carriage Bolt (95)
already inserted into the Butterfly Base (4). Secure
the Pulley with a 3/8” Nylon Jamnut (63). Make sure
the Cable Trap is oriented as shown.
Route the threaded end of the Ab Cable (74) under
the 3 1/2” Pulley (24) that is already mounted on the
Weight Base (5). Make sure the Cable is routed in
the direction shown.
Note: For clarity, this and the following drawings
show some parts removed.
28
63
74
95
5
4
82
57
24
50
66
Bracket
End of
Cable
74
30. Attach the threaded end of the Ab Cable (74) to a “U”-
Bracket (97) with a 1/4” Flat Washer (71) and a 1/4”
Nylon Locknut (68).
Attach the “U”-Bracket (97) to the hole in the Short
Weight Tube (17) with a 5/16” x 1 3/4” Bolt (96) and a
5/16” Nylon Locknut (64). Note: Do not completely
tighten the Nylon Locknut; it should be threaded
only two turns onto the end of the Cable, as
shown in the inset drawing.
25
24
30
97
96
74
71
64
68
17
29
74
97
71
68