Filter
Top Products
8
7. Press three 50mm Square Inner Caps (36) into the
Leg Lever (32). Press a 1” Round Inner Cap (41)
into the Leg Lever. Press a 1” Angle Cap (5) onto
the Leg Lever.
8. Lubricate the M10 x 72mm Bolt (10). Attach the Leg
Lever (32) to the Front Leg (22) with the Bolt and
an M10 Nylon Locknut (14).
9. Tap 3/4” Round Inner Caps (43) into each end of
the three Pad Tubes (38).
Insert a Pad Tube (38) through one hole in the Leg
Lever (32). Insert another Pad Tube through the
other hole in the Leg Lever. Insert the remaining
Pad Tube through the hole in the Front Leg (22).
Slide two Foam Pads (48) onto each Pad Tube (38).
10. Set each section of the Base (20, 55) on the floor.
Be sure that the indented side of each section of
the Base is facing the floor. Press a 50mm Square
Inner Cap (36) into the indicated end of each sec-
tion of the Base.
Insert four M8 x 58mm Carriage Bolts (6) into each
section of the Base (20, 55).
10
7
8
9
36
32
5
36
41
32
14
48
48
36
20
55
6
6
6
6
48
43
43
43
43
22
32
43
10—Lubricate
22
38
38
48
48
38
The indented
side must face
the floor