Filter
Top Products
8
8
B
39
21
31
8
8
55
20
31
16
ADJUSTING THE WIDTH OF THE SQUAT RACK
If you buy a new barbell, you may need to change the
width of the squat rack. If you are using an olympic
barbell, you must use the wide setting. If you are
using a five or six foot long barbell, you must use
the narrow setting.
To move the squat rack from the narrow setting to
the wide setting: Remove the Adjustment “U” Bracket
(31), four M8 x 68mm Bolts (8), and four M8 Nylon
Locknuts (12) from each section of the Base (20, 55).
Remove the Adjustment “U” Bracket (31), four M8 x
68mm Bolts (8), and four M8 Nylon Locknuts (12) from
each section of the Top Frame (21, 39). Re-assemble
the Base and Top Frame in the wide position, as shown
in the main drawing. Attach the Spacer Tube (1) inside
the upper Adjustment “U” Bracket (31) with two M8 x
68mm Bolts (8) and two M8 Nylon Locknuts (12).
To move the squat rack from the wide setting to the
narrow setting: Remove the Adjustment “U” Bracket
(31), four M8 x 68mm Bolts (8), and four M8 Nylon
Locknuts (12) from each section of the Base (20, 55).
Remove the Adjustment “U” Bracket (31), six M8 x
68mm Bolts (8), six M8 Nylon Locknuts (12), and the
Spacer Tube (1) from each section of the Top Frame
(21, 39). Re-assemble the Base in the narrow position,
as shown in drawing A. Re-assemble the Top Frame in
the narrow position, as shown in drawing B. Save the
Spacer Tube (1), the two extra M8 x 68mm Bolts (8),
and the two extra M8 Nylon Locknuts (12) for future
use.
A
1
12
8
39
21
31
31
8
12
12
55
20
WARNING: Do not use a barbell longer than six
feet when the squat rack is set to the narrow
width. If you are using an olympic barbell you
must set the squat rack to the wide width.