Filter
Top Products
23. Press a 1” Round Inner Cap (41) into each end of a
Spotter Tube (4).
Press a 1” Round Inner Cap into each end of the
other Spotter Tube (not shown).
24. Insert a Spotter Tube (4) through a Front Upright
(18) and into a Rear Upright (19). Rotate the
Spotter Tube so that the hook locks in place around
the Front Upright.
Insert the other Spotter Tube through the other
Front and Rear Upright (not shown) in the same
manner. Be sure that the Spotter Tubes are
inserted at the same level on both sides.
25. Attach the indicated Handle (27) to one of the
Cables (51) by inserting the hook on the end of the
Handle through the loop in the end of the Cable.
Attach the other Handle to the other Cable (not
shown) in the same manner.
26. Make sure that all parts are properly tightened before you use the weight bench.
24
25
13
27
51
Loop
Hook
4
18
19
23
41
41
4