15
5
STEP
• Attach the weight stack tower bracket
(Z35) to the weight stack tower using two
bolts (M10x65), four flat washers
(10.2x22x2), and two nylon nuts (M10).
• To attach the swing arm (AF3) and range
of motion plate (AF1), slide the 297mm axle
through hole in bracket on swing arm
support (AC4). Slide on a flat washer
(20.5x26.5x4), swing arm, wavy washer
(20.7x29.1x0.3), and range of motion
plate, in that order. The axle should then go
through the weight stack tower bracket and
be secured with a bushing, flat washer
(13x26x2.5), lock washer (12.2x21.5x3),
and bolt (M12x25). Make sure the flats on
the axle match up with those on the brackets.
• Slide the workout handle (AE1) onto the
shaft of the swing arm (AF3) and secure
using a large flat washer (12.5x38x3), a
flat washer (13x26x2.5), a lock washer
(12.2x21.5x3), and a bolt (M12x25).
Lifting the handle slightly will reveal an opening
in the shaft that a bolt (M8x20) can be
threaded into to prevent the workout handle
from flopping around dangerously. Attach
the counterweight to the swing arm using
two bolts (M10x25) and two flat washers
(10.2x22x2). Tighten all hardware. Make
sure the swing arm axle is level after
hardware is tightened.
BLACK BAG
AC4
AC4
AE1
AE1
AF3
AF3
AF1
AF1
Z35
Z35